Project progress
M/E Replaced Fuel Pump Inlet Oil Pipe & Additional Support Reinforcement for CMA CGM CONCORDE

Project Name:

M/E Replaced Fuel Pump Inlet Oil Pipe & Additional Support Reinforcement for CMA CGM CONCORDE

Project Start Time:

2024-05-15 15:52

Decoration style:

othere

Project description:

M-0566 M/E Replaced Fuel Pump Inlet Oil Pipe & Additional Support Reinforcement

Progress:

Disassemble the old fuel pump inlet oil pipe

Close the valve and remove the old fuel pump inlet oil pipe and its bolts and brackets

First of all, remove the accessories of the oil pipe, and then remove the oil pipe and gasket, while paying attention to the oil in the pipeline. Then install the new gasket and pipe and bolt tighten,Note the calibration position.Finally, add support installation and reinforcement. Disassembly the pipe & Bolts & Brackets Oil outlet Dismounting gasket Old gasket

Progress:

Install new inlet oil pipe & Support

Clean the contact surfaces of the pipes, install new gaskets and pipes, and tighten the bolts. New pipe supports are then installed for reinforcement to prevent vibration.

New inlet oil pipe New gasket New pipe Cleaning contact surface Install new pipe & Gasket Adjust location Bolt tighten Additional support reinforcement

Progress:

Installation complete

Installation complete

Progress:

Job done

Job done